Enabling External IR Input
Posted: Fri 3. Aug 2012, 19:20
Hi,
This could be a very dumb question, but hopefully not
I have an Ethernet IRTrans with an Internal receiver - I've used that to learn most of the codes I want, but now I want to use the External IR input to Feed a direct signal into the device from my Philips Pronto Receiver, since I only want specific commands passed to it and the pronto has 4 outputs.
The manual says to remove the red jumper behind the internal IR input, but upon having a look, I can't see any jumpers on the board at all, never mind a red one - Am I missing something?
Cheers!
- Dan/Reo
This could be a very dumb question, but hopefully not
I have an Ethernet IRTrans with an Internal receiver - I've used that to learn most of the codes I want, but now I want to use the External IR input to Feed a direct signal into the device from my Philips Pronto Receiver, since I only want specific commands passed to it and the pronto has 4 outputs.
The manual says to remove the red jumper behind the internal IR input, but upon having a look, I can't see any jumpers on the board at all, never mind a red one - Am I missing something?
Cheers!
- Dan/Reo