IRTrans Support Forum

Hi there!

I installed 2 IRTrans Ethernet devices w/o DB and successfully can control one of them on bus 0 via command line:
"IRClient.exe localhost device comman 0 0 E".

If I'm trying to control device 2 on bus 1 with "IRClient.exe localhost device comman 0 1 E" I'm always confronted
with the error message "IR Error: Specified Bus does not exist".

Both devices are identified by the server; shown on IRTranstray LAN diagnostics (Windows) and IRClient status
(command line). If I'm configuring the .rem-file for the IRTrans Client with the SDEVICE-Parameter, I can choose
between Bus 0 and 1.

The IRServer is started with the parameters "-http_port 1111 IP1;IP2"; the software versions are the latest.

Is there any way to get rid of the error?

Thanks in advance!

Hi,
that is strange, the syntax is correct and should work.

Please start the irserver with the additional options "-loglevel 4" and send us a screenshot what happens when you are sending to bus 0 and to bus 1.

The screenshot should also include software and firmware versions.

IRTrans

Hello again,

here comes the screenshot while running the client trying to access both devices.
I hope this is helpful.

Best regards!

Strange - looks like bus 1 gets identified as bus 2 by the irserver. Looks like a bug in the irclient.exe.

We will check that here.

Please send us an Email to support@irtrans.de so that we can then send you a patched irclient.exe.

IRTrans

We have fixed that - attached the version 6.00.05.

IRTrans