IRTrans Support Forum

Hi all,

I have a brand new Ethernet IRTrans module delivered today. The manual says that it is configured to work with dhcp, but if i look at my dhcp server log there is no lease to the device. Then I try to connect to 192.168.0.32, but no success either.
If i plug in the AC adapter, the LED becomes green, and after approx. 500 ms red. Another 500 ms later the LED is off. On the RJ45 socket, the green LED is on and the yellow is flashing at the beginning.
From my point of view I have no chance to use the device.

Best regards
Dierk

Hi,
the blinking of the LED is correct.

The LED status of the LAN Connector is correct, too.

Please use the ip_assign tool that is part of the SW to check if and what IP address is in use.

IRTrans

IRTrans wrote:Hi,
the blinking of the LED is correct.

The LED status of the LAN Connector is correct, too.

Please use the ip_assign tool that is part of the SW to check if and what IP address is in use.

IRTrans

The ip_assign tool is not working with linux ( cannot execute binary file ). I try to use the windows version in a VM, but it find no device

OK, we will upload a working version of ip_assign later today / this evening.

IRTrans