IRTrans Support Forum

I'm trying to upload IR commands to the Multistream's integrated IR database.
The IR server runs and connects succesfully with the Multistream unit (IR version E6.06.30, Ethernet version L1.10.12), but when I start the IR Trans client (7.0.27.35771) and select "mode > device database" a message saying "result: [4 -3 ] timeout" appears.
Sending IR from the local IR server database works without problem though ...

So, how do I upload the IR commands from the local database to the Multistream's integrated IR database?

Hi,
please check if you are using a current SW version. Earlier SW versions do not support the IRTrans Multistream device.

You can also download a current version from our website.

IRTrans

Thanks, that worked!

I have one more question: I'm using the UDP ASCII protocol for sending IR codes out through one of the outputs (snd <remote>,<command>,[ledselect],[sendmask]).
But whatever I try, the command is always sent to all the outputs of the Multistream, can you tell me what the format is I have to use in order to send the command to a single output?

Hi,
to select ports with the Multistream device the sendmask is used.

It is a bitmask and allows to select any combination of ports:

1 = Port 1
2 = Port 2
4 = Port 3
8 = Port 4
16 = Port 5
....
16384 = Port 15
32768 = Port 16

7 would select Port 1 + 2 + 3.

The LED Select parameter is not used for the IRTrans Multistream.

IRTrans

Sorry, specifying the sendmask has no effect, the Multistream keeps sending the IR commands to all outputs.

I tried "snd humax,chan+,1,1", "snd humax,chan+,E,1", , "snd humax,chan+,0,1" and other combinations without succes.

Hi,
you need to add an "m" in front of the sendmask (sorry, that is not mentioned in the docs):

snd humax,chan+,m1

Furthermore when using led selection (for other IRTrans devices) you need an "l" in front of the parameter.

IRTrans

It works! Thanks for your quick response!