Hi. I have the WIFI module and I suspect there may be an issue. Until now I've only ever used the USB connection. For the most part the irTrans works fine, however every so often (and I can't replicate the problem to know the frequency - roughly once a week) it will stop responding. Any thoughts why? So I thought I would try to connect using WIFI only to see if that makes a difference.
But there is no success either. The status LED turns itself off and from what I can gather from the forum, this should remain green all the time. Is that correct? I've uploaded a video here (http://gallery.me.com/gregconnors#100114) showing the power-on LED sequence. The transmit/receive LED glows green then red, then the status LED glows red green and then flickers red briefly. Then another LED (not sure what it represents) glows green continually. Is this normal?
I am using a Mac so can't manually adjust the device's IP address, but my network is 192.168.0.x so the default 192.168.0.32 should work but is doesn't (ie. wont ping), and there is no reference to the device in my logs. I have even tried a DHCP mapping entry to the MAC address, but no luck there either. I also tried to reset the device (which is why it's out of it's case) by putting jumper on the two pins closest to the status LED (I hope that was correct). Can you make any suggestions for steps to take to improve my devices reliability.
I am using a Mac Mini 2.4 Core Duo, with iRed v2.1.2. Thanks in advance.